| Revision:

root @ 206

Name Size Revision Age Author Comment
  docs 110 over 14 years Kevin Woo Added the datasheet for the 485 chip and the 48...
  trunk 206 almost 14 years Kevin Woo Moved the uart code to rs485_int since that des...

Latest revisions

# Date Author Comment
206 02/27/2010 04:52 PM Kevin Woo

Moved the uart code to rs485_int since that describes it better.

205 02/27/2010 04:16 PM Kevin Woo

Removing serial.c since we have a uart one

204 02/26/2010 01:51 PM Kevin Woo

Some byte hacks to reduce size.

203 02/26/2010 01:49 PM Kevin Woo

Moved the uart code from toolbox to cardbox since toolbox now uses the bootloader rs485 code

202 02/26/2010 01:47 PM Kevin Woo
  • Moved the reset code to toolbox since it is the only code that uses it
  • Optimized the toolbox statemachine to use parse_packet and the bootloader
  • Small byte optimizations.
  • Down from 1024 bytes to 768 bytes
201 02/26/2010 01:06 PM Kevin Woo
  • Setup bootloader to initialize pins to a known safe state
  • Pulled pindefs for the toolbox out of the toolbox into common/toolbox_pindefs.h
  • Shared toolbox pindefs with the bootloader
  • Replaced all raw pin names with the #defined names
  • Optimizied out some bytes out of the bootloader by sharing variables
200 02/24/2010 10:59 PM Kevin Woo

Bootloader only emits a boot message when the buttons are depressed or it was reset by a watchdog

199 02/24/2010 10:16 PM Kevin Woo

Bootloader is setup to read the address from the EEPROM now

198 02/24/2010 06:24 PM Kevin Woo

Fixed a magic number initialization

197 02/24/2010 06:21 PM Kevin Woo

Removed fuse writing since it seems to be placing the fuses out of memory and causing the programmer to fail

View all revisions | View revisions

Also available in: Atom