| Revision:

root @ 203

Name Size Revision Age Author Comment
  docs 110 almost 14 years Kevin Woo Added the datasheet for the 485 chip and the 48...
  trunk 203 almost 13 years Kevin Woo Moved the uart code from toolbox to cardbox sin...

Latest revisions

# Date Author Comment
203 02/26/2010 01:49 PM Kevin Woo

Moved the uart code from toolbox to cardbox since toolbox now uses the bootloader rs485 code

202 02/26/2010 01:47 PM Kevin Woo
  • Moved the reset code to toolbox since it is the only code that uses it
  • Optimized the toolbox statemachine to use parse_packet and the bootloader
  • Small byte optimizations.
  • Down from 1024 bytes to 768 bytes
201 02/26/2010 01:06 PM Kevin Woo
  • Setup bootloader to initialize pins to a known safe state
  • Pulled pindefs for the toolbox out of the toolbox into common/toolbox_pindefs.h
  • Shared toolbox pindefs with the bootloader
  • Replaced all raw pin names with the #defined names
  • Optimizied out some bytes out of the bootloader by sharing variables
200 02/24/2010 10:59 PM Kevin Woo

Bootloader only emits a boot message when the buttons are depressed or it was reset by a watchdog

199 02/24/2010 10:16 PM Kevin Woo

Bootloader is setup to read the address from the EEPROM now

198 02/24/2010 06:24 PM Kevin Woo

Fixed a magic number initialization

197 02/24/2010 06:21 PM Kevin Woo

Removed fuse writing since it seems to be placing the fuses out of memory and causing the programmer to fail

196 02/24/2010 05:57 PM Kevin Woo
  • Fixed bug where the naked attribute did not work with main
  • Used a noreturn attribute to main_start which saved us some room. That works
  • Tested removal of interrupt tables, this works
195 02/24/2010 03:54 PM Kevin Woo

Using a modified linker script to strip out the unused interrupt vector table in the bootloader. Not tested

194 02/24/2010 02:47 PM Kevin Woo

Added default fuses to the bootloader

View all revisions | View revisions

Also available in: Atom