Project

General

Profile

Activity

From 10/08/2011 to 11/06/2011

11/07/2011

08:06 PM Revision 0b2acc15: Changed center ground pad for DS2786 and LT3650
Changed ground pads for packages 10MSOP and 12TDFN to have through-hole
pads on the bottom instead of SMD pads. Updat...
Abraham Levkoy
07:12 PM Revision 1bc70a1f: Updated power test schematic
Based on feedback from Kevin, added a pullup resistor to !PWR_INT and
decoupling caps to the LDO providing VCC.
Also...
Abraham Levkoy

11/06/2011

09:40 AM Revision 0f8a07ab: Minimized possible inductive loop in power board
Moved trace driving FAULTLED to minimize area of inductive loop in
vicinity of charger.
Abraham Levkoy
09:21 AM Revision e5134b5f: Finished power board routing (first attempt)
Routed all signals on power test board. There are no airwires, and the
board passes DRC. I believe I have kept the in...
Abraham Levkoy
08:33 AM Revision aa7ee9ae: Partially routed charger on power test board
Routed some of the signals connected to the charger IC on the power test
board.
Abraham Levkoy
08:07 AM Revision d468084c: Routed gas gauge on power board
Routed signals attached to fuel gauge on power board. Abraham Levkoy
03:40 AM Revision 1e62ac51: Started to route LDO signals
Started routing the signals attached to one of the LDOs. Abraham Levkoy
03:10 AM Revision ebfa6fb9: Finished routing AVR and FTDI, started pushbutton
Finished routing signals connected to AVR and FTDI on power test board.
Started routing signals attached to pushbutto...
Abraham Levkoy
01:56 AM Revision 8b6cb5d4: Routed USB circuit and most of AVR on power board
Routed most of the signals connecting the USB port, FTDI chip, and AVR. Abraham Levkoy
10:46 PM Revision 1a5559b0: Changed USB port drill holes back to spec
Looked at mini USB port with Dan. Observed that corner drill holes are
supposed to be multiple drills right next to e...
Abraham Levkoy

11/05/2011

07:05 PM Revision 30d533fe: Preliminary power board placement complete
Placed all parts on power test board in what I believe will be their
approximate final locations. No routing done yet...
Abraham Levkoy
06:17 PM Revision 9180be39: Partial placement of power board
Placed AVR, FTDI chip, and USB port on power test board, along with
their accessory components. They are probably pre...
Abraham Levkoy
05:29 PM Revision 00c7cdb1: Changed IO voltage for FTDI IC on power board
Changed VCCIO input for FTDI chip on power test board from USB_VCC to
internally generated 3.3V signal. This should h...
Abraham Levkoy
04:00 PM Revision 344a6bf3: Fixed ERC errors from unconnected wires
Some wires created in the previous few commits were not actually
connected to the pins they ended at. I fixed them.
Abraham Levkoy
03:20 PM Revision 13790121: Changed Schematic
Tied USB Shield pin to ground Julian Binder
03:09 PM Revision 168d92e6: Changed Schematic
Added activity LED's to the FT232 chip using the TXLED and RXLED pins Julian Binder
03:00 PM Revision 53d8e950: Changed Schematic Per Kevin Woo's Email
Changed U5 VSS from GND to VBATT_GND
Added GND PIN connection to ISP header
Switched USB_TX and USB_RX pins on the...
Julian Binder
02:39 PM Revision eed7abeb: Updated Schematic File
Added missing capacitor between Vin and GND in the charge circuit. Julian Binder
02:14 PM Revision 9b2f29ed: Fixed some schematic errors identified by the ERC.
Connected capacitor C12 which apeared connected but was actually
disconnected.
Approved error of VCC being connect t...
Julian Binder

11/04/2011

06:39 PM Revision 90591b4b: Undo accidental extraction of zipped Gerber files
Restored compressed Gerber files from commit
6bcd5b932bde03c525653653638fddd5251a5705 after they were accidently
unco...
Abraham Levkoy
06:10 PM Revision 33c4366f: Updated DS2786 footprint in kwoo library
Updated package footprint for DS2786 in kwoo.lbr based on recommended
land placement in datasheet for DFN10 package. ...
Abraham Levkoy
05:09 PM Revision 51b65a87: Increased mini-USB plug drill hole size
Imported MINI-USB- device from Hirose Connectors library into kwoo
library. In UX60-MB-5S8 package, increased drill h...
Abraham Levkoy
03:12 PM Revision fc0c916c: Updated inductor package for power board
Created new package and device in library for MPI4040 inductor to be
used in power test board. Updated part on power ...
Abraham Levkoy
04:10 AM Revision 109296da: Fixed GND pad on LT3650 charger IC
LT3650 package in kwoo.lbr had a polygon around a through-hole pad to
approximate a large SMD pad connected by a via ...
Abraham Levkoy
02:57 AM Revision 4327ce8c: Updated design rules for power board
Updated design rules for power board to match DorkbotPDX specifications.
This removed some of the DRC errors for the ...
Abraham Levkoy
12:42 AM Revision d3af95cc: Added new charger and pushbutton controller parts
Added LT3650 and LTC2954 to kwoo.lbr. Kevin sent me an updated library
with these parts previously, but I mistakenly ...
Abraham Levkoy
11:52 PM Revision a7a07a86: Disapproved DRC errors on power board
Disapproved of previously approved DRC errors for power board. They are
apparently legitimate problems that need to b...
Abraham Levkoy
10:32 PM Revision 072e0990: powerboard placed, needs routing
Yuyang Guo

11/03/2011

05:28 AM Revision 6bcd5b93: Fixed gas gauge and charging components
Added extra decoupling capacitor between battery voltage and ground next
to charging circuit to allow board to run wi...
Abraham Levkoy
03:34 AM Revision cbe8706d: Added missing components around AVR on power board
Added ISP header, pullup resistor for AVR reset line, and decoupling
capacitors for AVR power lines. Connected ISP he...
Abraham Levkoy
02:37 AM Revision cb409f92: Finished USB interface on power board
Added decoupling capacitors to FTDI chip, changed signaling VCC from USB
VCC to AVR VCC so that AVR can signal to FTD...
Abraham Levkoy

11/02/2011

07:15 PM Revision 8c16f5aa: Started to add USB port to power board
Added USB port and USB-UART converter to power board schematic. I think
the converter has enough hooked up to it to r...
Abraham Levkoy
05:10 AM Revision 107d33d7: Shorted GND to BATT_GND in power schematic
Connected GND and BATT_GND to eachother using a 0 Ohm resistor. I want
to keep the signals separate to ease routing, ...
Abraham Levkoy
04:35 AM Revision 9f7d5c6f: Fixed ERC errors
Added some missing junctions and a missing label. Approved "no value"
warnings for parts for which a value would be n...
Abraham Levkoy
03:24 AM Revision f6a93a04: Started making kwoo's recommended changes
Made changes to charging circuit: Connected CLP to VIN on U1. Added
diodes to charge BOOST capacitor from battery and...
Abraham Levkoy

11/01/2011

03:13 AM Revision aa3e7f85: Update prefixes and names for two parts
Updated prefixes for DS2786 and MP1702 in kwoo.lbr to U so that Eagle
won't use the default prefix, U$, for them. Als...
Abraham Levkoy

10/27/2011

05:03 AM Revision 680676e5: Added pullup resistors and an LED to power test
Added pullup resistors for I2C connections to power test board. Also
added a diagnostic LED to indicate when the AVR ...
Abraham Levkoy
04:20 AM Revision 0d19b5ca: First draft of power testing circuit schematic
Fleshed out power testing circuit. It is still missing a few things, and
I don't understand every little bit of it, b...
Abraham Levkoy
11:59 PM Revision 94e948f2: Updated charging test circuit from kwoo library
Ran update command in charging_test.sch to update parts from kwoo.lbr. Abraham Levkoy
10:27 PM Revision acbd1e46: Updated kwoo.lbr with previous kwoo changes
A few months ago, Kevin sent me a new version of kwoo.lbr. Updated
kwoo.lbr with these changes (using the Eagle updat...
Abraham Levkoy
09:10 PM Revision 5a7bbf4c: fixing last 13 angle problem in drc
don't really know how to fix the last one.
worked on right bottom on both top layer and bottom layer
Yuyang Guo

10/23/2011

10:19 AM Revision a433b5ff: solving some angle problems on scoutflu board
Yuyang Guo

10/22/2011

05:32 PM Revision cf5c3070: Fixed some of the paths which are at unusual angles
Thomas Mullins
05:03 PM Revision ca0c1be9: fixing some of the angle problems in scoutfly.sch
Yuyang Guo
04:18 PM Revision 0f971c62: Revert "Test commit"
This reverts commit d2d61ecc68a436f01f7f85756ca0709399543268.
Test revert for demonstration purposes.
Yuyang Guo
04:16 PM Revision d2d61ecc: Test commit
Created a new file for demonstration purposes. Yuyang Guo
 

Also available in: Atom