Project

General

Profile

Statistics
| Branch: | Revision:

scoutece / lbr @ f4a85021

Name Size
2layer.cam 7.08 KB
4layer.cam 9.88 KB
4layer_6mil_15mil.dru 1.97 KB
goldphoenix.dru 1.91 KB
jabinder.lbr 21.8 KB
kwoo.lbr 197 KB
rc.lbr 14.2 KB

Latest revisions

# Date Author Comment
b3776a44 02/17/2013 01:55 PM Julian Binder

added new batboard to repo. also added new charge controller to the
library.

68b83291 02/15/2013 06:54 PM Julian Binder

finished charge schematic with exception of temp sense resistors.
Debating whether this is even necessary.

6dddacca 12/15/2012 03:47 PM Julian Binder

fixed library errors. also finished battery board

b4cb37e1 11/11/2012 04:45 PM Julian Binder

Added UCC3911 Lithium-Ion Battery Protector to jabinder.lbr
Also added UCC3911 to schematic with associated perhiperals

b76ae2da 11/11/2012 12:12 AM Julian Binder

Created a new library jabinder.lbr
Added parts for 18650 double battery holder, LT3650 two cell li-ion battery
charger and 2x2 SMT molex headers
Also made schematic for a board that charges batteries that can
be added to the battery holder so tht such circuit is not neccessary on...

a675468b 03/18/2012 08:17 PM Julian Binder

Made changes that Abe recommended:
Fixed SHDN pin connection.
Changed inverter voltage level from 5V to 3.3V.
Modified PB Controller to have value displayed.
TODO: Address concerns about shutdown timing and switch power loss.

ba8bd0b5 03/08/2012 06:19 PM Julian Binder

Added a new push button controller circuit. Uses new IC instead of solid state machine because there was no room for solid state machine circuit. Preformed changes that Abe recommended. Routed new circuits. Board should be ready to send back out to kwoo.

8d6c686a 03/07/2012 10:05 PM Julian Binder

Added new switching power supply for 5V and 3.3V supplies. Routed board to include these, and switch.

a8b095dd 03/06/2012 09:51 PM Julian Binder

Added packages to kwoo for diode, dd2pak for switching regulator and switch. Working on schematic for the new power system using switching regulator.

0b2acc15 11/06/2011 08:06 PM Abraham Levkoy

Changed center ground pad for DS2786 and LT3650

Changed ground pads for packages 10MSOP and 12TDFN to have through-hole
pads on the bottom instead of SMD pads. Updated power test board to use
the new DS2786. Drew a polygon of BATT_GND around center pad. Not sure...

View revisions

Also available in: Atom