Project

General

Profile

Statistics
| Branch: | Revision:

scoutece / scoutfly @ 0b2acc15

Latest revisions

# Date Author Comment
0b2acc15 11/06/2011 08:06 PM Abraham Levkoy

Changed center ground pad for DS2786 and LT3650

Changed ground pads for packages 10MSOP and 12TDFN to have through-hole
pads on the bottom instead of SMD pads. Updated power test board to use
the new DS2786. Drew a polygon of BATT_GND around center pad. Not sure...

1bc70a1f 11/06/2011 07:12 PM Abraham Levkoy

Updated power test schematic

Based on feedback from Kevin, added a pullup resistor to !PWR_INT and
decoupling caps to the LDO providing VCC.

Also changed the ground signal on the gas gauge LDO from GND to
BATT_GND. Kevin pointed out that having BATT_GND as the ground for the...

0f8a07ab 11/06/2011 09:40 AM Abraham Levkoy

Minimized possible inductive loop in power board

Moved trace driving FAULTLED to minimize area of inductive loop in
vicinity of charger.

e5134b5f 11/06/2011 09:21 AM Abraham Levkoy

Finished power board routing (first attempt)

Routed all signals on power test board. There are no airwires, and the
board passes DRC. I believe I have kept the inductive loops near the
charger pretty small, but they could probably be improved. I also made...

aa7ee9ae 11/06/2011 08:33 AM Abraham Levkoy

Partially routed charger on power test board

Routed some of the signals connected to the charger IC on the power test
board.

d468084c 11/06/2011 08:07 AM Abraham Levkoy

Routed gas gauge on power board

Routed signals attached to fuel gauge on power board.

1e62ac51 11/06/2011 03:40 AM Abraham Levkoy

Started to route LDO signals

Started routing the signals attached to one of the LDOs.

ebfa6fb9 11/06/2011 03:10 AM Abraham Levkoy

Finished routing AVR and FTDI, started pushbutton

Finished routing signals connected to AVR and FTDI on power test board.
Started routing signals attached to pushbutton controller.

8b6cb5d4 11/06/2011 01:56 AM Abraham Levkoy

Routed USB circuit and most of AVR on power board

Routed most of the signals connecting the USB port, FTDI chip, and AVR.

1a5559b0 11/05/2011 10:46 PM Abraham Levkoy

Changed USB port drill holes back to spec

Looked at mini USB port with Dan. Observed that corner drill holes are
supposed to be multiple drills right next to eachother. Decided to
change holes back to specfied radius and ignore long hole for now.

View revisions

Also available in: Atom