Activity
From 12/14/2009 to 01/12/2010
01/13/2010
01/12/2010
- 05:04 PM Task #978 (Assigned): System Wiring
- Formalize lengths, gauges, and organization of wiring for sensors and actuators. Signals should be transferred on the...
- 05:01 PM Task #976: Scoutfly Connectors
- This looks like a good, fairly low cost solution. Routing power/gnd separately is no problem.
- 02:09 PM Task #976: Scoutfly Connectors
- There are a lack of 40pin FFC connectors, the common sizes seem to be <= 30 pins. We can do 2 20-pin connectors to me...
- 11:42 AM Task #976 (Fixed): Scoutfly Connectors
- Find 40+pin FFC (flexible flat cable) connector and cable (4+" length)
Find as inexpensive as possible (<$5 ideal) - 11:59 AM Task #974: Accessory Ball Bearing
- Use bushing instead of bearing (overkill)
Low profile (3/8" thickness) flange not necessary, but is good if we hav... - 05:32 AM Task #974 (Fixed): Accessory Ball Bearing
- Add block for ball bearing and choose part
Recommend 0.250" ID, plain vanilla ball bearing (read: cheap) or use simp... - 05:34 AM Task #973 (Fixed): Share schematic + board on dropbox with dan
- 07:30 PM Task #973 (Fixed): Share schematic + board on dropbox with dan
- 05:34 AM Task #975 (Wontfix): Hood Buttons
- Once dev board layout is finalized (for dev), design buttons and determine placement on hood piece.
Buttons may be... - 08:32 PM Enhancement #971 (Fixed): Remove led bar and use individual LEDs instead
01/11/2010
- 10:57 PM Enhancement #972 (Fixed): Replace RF chip crystal with smaller oscillator
- http://search.digikey.com/scripts/DkSearch/dksus.dll?Detail&name=535-10013-1-ND
is 100 x 100 mils - 10:55 PM Enhancement #971 (Fixed): Remove led bar and use individual LEDs instead
- * red, green, same as the FTDI's
* Add 1 more of each so that we can fully utilize those pnps
- 10:55 PM Task #970 (Fixed): Find all resistors we need
- 0603 unless it can't withstand the power disspation
01/10/2010
- 04:06 PM Task #969 (Fixed): Look for smaller ethernet connector
- Current one takes up a significant amount of room on the board
- 03:59 PM Task #968 (Fixed): Double-check Resistor Divider Values
- Some may be reversed
- 03:59 PM Task #967 (Fixed): Double-check IC Footprints
- Some may be reversed
Also available in: Atom