Mill¶

• The mill machine switch cuts both hot and neutral

Tooltron Configuration¶

• Tooltron board ID: 4
• tooltron is connected after the switch on the neutral line (between switch and motor)
• a hot line is also running through the mill for the current sense after the switch
  • test line is hot when switch is on regardless of motor spinning

Wiring¶

• green/yellow: earth ground
• blue from wall -> red in machine: right prong when facing male plug w/ ground @ bottom (should be neutral at wall)
• brown from wall -> black in machine: left prong when facing plug (should be hot at wall)

Seems to follow european coloring standards:¶

• The live conductor must be brown
• The neutral is blue
• The earth ('safety ground') must be green/yellow

Drill Press 1¶

• The drill press close to the door
• Board ID: 3

Drill Press 2¶

• The drill press closer to the wall
• Board ID: 8