Statistics
| Branch: | Revision:

root / scoutfly @ 072e0990

Latest revisions

# Date Author Comment
072e0990 11/03/2011 10:32 pm Yuyang Guo

powerboard placed, needs routing

6bcd5b93 11/03/2011 05:28 am Abraham Levkoy

Fixed gas gauge and charging components

Added extra decoupling capacitor between battery voltage and ground next
to charging circuit to allow board to run with charger but no battery.
Connected system side of gas gauge sense resistor to GND to make all
current returning to battery go through sense resistor. Removed 0 Ohm...

cbe8706d 11/03/2011 03:34 am Abraham Levkoy

Added missing components around AVR on power board

Added ISP header, pullup resistor for AVR reset line, and decoupling
capacitors for AVR power lines. Connected ISP header to SPI interface on
AVR.

cb409f92 11/03/2011 02:37 am Abraham Levkoy

Finished USB interface on power board

Added decoupling capacitors to FTDI chip, changed signaling VCC from USB
VCC to AVR VCC so that AVR can signal to FTDI chip. Added USBTX and
USBRX signals between FTDI chip and AVR.

8c16f5aa 11/02/2011 07:15 pm Abraham Levkoy

Started to add USB port to power board

Added USB port and USB-UART converter to power board schematic. I think
the converter has enough hooked up to it to run without burning up, but
it's not hooked up the AVR yet.

107d33d7 11/02/2011 05:10 am Abraham Levkoy

Shorted GND to BATT_GND in power schematic

Connected GND and BATT_GND to eachother using a 0 Ohm resistor. I want
to keep the signals separate to ease routing, but they need to be
connected to ensure that all of the current that needs to go through the
fuel gauge sense resistor does so.

9f7d5c6f 11/02/2011 04:35 am Abraham Levkoy

Fixed ERC errors

Added some missing junctions and a missing label. Approved "no value"
warnings for parts for which a value would be nonsensical.

f6a93a04 11/02/2011 03:24 am Abraham Levkoy

Started making kwoo's recommended changes

Made changes to charging circuit: Connected CLP to VIN on U1. Added
diodes to charge BOOST capacitor from battery and provide current
sensing inductor with outlet if power turns off (don't really understand
how the latter works). Adjusted inductor to 4.7uH after re-calculating...

aa3e7f85 11/01/2011 03:13 am Abraham Levkoy

Update prefixes and names for two parts

Updated prefixes for DS2786 and MP1702 in kwoo.lbr to U so that Eagle
won't use the default prefix, U$, for them. Also manually updated names
in charging_test.{sch,brd}.

680676e5 10/27/2011 05:03 am Abraham Levkoy

Added pullup resistors and an LED to power test

Added pullup resistors for I2C connections to power test board. Also
added a diagnostic LED to indicate when the AVR has power. Still
probably needs an ISP header and USB controller/port.

View revisions

Also available in: Atom